| 1. For a honningovaniye it is recommended to use "brush". Previously put covers of radical bearings and tighten bolts with the set moment. |
| 2. Clamp adaptation in the electric drill. |
|
3. Well oil the surface of the cylinder, turn on the electric drill and periodically move up and down in the cylinder. At the same time on a surface of walls of the cylinder the structure of the thin lines which are crossed at an angle about 60 ° has to be formed. To get the brush only after a full stop of a drill. |
| 4. After a honningovaniye carefully clear and wash out the block of cylinders. At sufficient degree of purity on the pure white rags moistened with oil there should not be particles of gray color if to carry out by her on a cylinder wall. |
