|
1. Wash out a bent shaft solvent and dry compressed air, clean oil channels, clear necks. |
|
2. Remove with a file agnails. |
|
3. Check a condition of necks of a shaft, existence of cracks, hollows, zadir. Check a roughness of necks, having rubbed about them a copper coin. If there are traces, then necks should be pereshlifovat. |
| |
4. Measure diameter of necks in several places on a circle and on length and define conicity and ovality. |
| 5. At noticeable damages or if conicity and ovality exceed norm, then the crankshaft should be pereshlifovat and replaced inserts repair. |
|
6. If on crankshaft necks under epiploons the deep flute from a working edge of an epiploon was formed, there are scratches or other damages, then the crankshaft is recommended to be replaced, or to prokonsultrovatsya in car service where a neck it is possible to chisel and napressovat the plug. If development from an epiploon deep, then even after installation of a new epiploon appears an oil leak. |
| 7. Check a condition of radical and connecting rods (see subsection 3.2.23). |
