|
|
| 1. Before installation of new piston rings sort rings and check a gap in joints. For this purpose push a ring the piston bottom. The ring has to be in the lower part of the cylinder, in the situation corresponding to the lower dead point. |
|
2. If the gap is too small, then a thin file carefully file ring end faces, having clamped it in a vice. Increase in a gap in a joint to 1,0 mm is allowed. |
| 3. Repeat the procedure for all rings of one piston. |
|
4. Install rings on the piston, having begun with oil scraper. Establish a ring divider / dilator in a flute. Be convinced available a pin of a flute (if it is provided) and establish the lower and top disks. |
|
5. At installation of oil scraper disks it is impossible to use the device for clothing of rings as their breakage is possible. Insert a disk, press also a finger since one end and carry out on a ring, having laid that its in a flute. |
| 6. Similarly install rings on other pistons. |
