BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. Running gear
   11.1.10. Back springs
   11.1.11. Bar of the back stabilizer of cross stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Angles of installation of wheels
   11.1.2. Specifications
   11.1.3. Stabilizer of cross stability of a forward suspension bracket
   11.1.4. Suspension bracket lever
   11.1.5. Rack of a forward suspension bracket
   11.1.6. Springs or shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. Nave of a forward wheel and bearing
   11.1.9. Back shock-absorbers
   + 11.2. Steering
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


11.1.3. Stabilizer of cross stability of a forward suspension bracket

1. Lift the car.
2. If the stabilizer changes or it is necessary to replace a suspension bracket rack, then disconnect a stabilizer cross-piece from its racks: turn off a nut of fastening of a cross-piece of the stabilizer to the top part of a rack (the top arrow). In case the suspension bracket lever changes, turn off a nut (the lower arrow) and disconnect from the lever a stabilizer rack assembled and an arm.
3. Turn off bolts and disconnect a plug arm from a body.
4. Turn off bolts of fastening of arms of plugs of the stabilizer to a suspension bracket cross-piece.
5. Remove the stabilizer. If necessary disconnect the stabilizer from an arm on a suspension bracket rack.
6. Installation is carried out upside-down. Delay all connections with the moments specified in section 11.1.2.