BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
- 11. Running gear
   11.1.10. Back springs
   11.1.11. Bar of the back stabilizer of cross stability
   11.1.12. Levers of a back suspension bracket
   11.1.13. Bearings of back wheels
   11.1.14. Angles of installation of wheels
   11.1.2. Specifications
   11.1.3. Stabilizer of cross stability of a forward suspension bracket
   11.1.4. Suspension bracket lever
   11.1.5. Rack of a forward suspension bracket
   11.1.6. Springs or shock-absorber of a rack of a suspension bracket
   11.1.7. Spherical support
   11.1.8. Nave of a forward wheel and bearing
   11.1.9. Back shock-absorbers
   + 11.2. Steering
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


11.1.13. Bearings of back wheels


Hug bearing of a back wheel

1. Nave

2. Lock ring

3. Case

4. Bearing


1. Release a nut of a half shaft and bolts of a back wheel. Lift a back part of the car and establish on supports.


On a part of cars follows at first it is necessary to remove a wheel, a nave cap, to establish a wheel and to release a half shaft nut.

2. Remove a half shaft.
3. On cars with back drum brakes remove a drum. On cars with back disk brakes remove a support and an arm. Do not disconnect a hose of a brake. Take a support aside and fix by a wire. Remove a brake disk. Blows to a mandrel beat out a nave from the bearing from the inside.
4. Remove a lock ring.
5. Blows to a mandrel to a vypressuyta the bearing from the case.
6. Assembly is carried out upside-down taking into account the following:
at a bearing press fitting the mandrel has to rest against its external holder, but not in internal, otherwise the bearing will be destroyed;
tighten a nut of a half shaft with the set moment (see subsection 9.2) after lowering of the car.