| 1. Disconnect the battery from weight. |
| 2. Disconnect a kick-down-cable and bring out of an arm on the soaking-up collector. |
| 3. On the M10 engine uncover the distributor. |
| 4. Lift the car. |
| 5. Remove exhaust pipes. |
| 6. Disconnect draft or a cable. |
| 7. Remove the driveshaft (see subsection 9.10). |
|
8. Merge transmission liquid. Disconnect tubes of a cooler of liquid and a filling branch pipe. |
|
9. On transmission 3HP22 in the lower part of a case of the hydrotransformer uncover, and at other check points remove an intensifying plate and the buffer limiter: dark shooters specified bolts which should be turned off. |
|
10. Through a window in a case turn off bolts of fastening of the hydrotransformer to a drive plate (3 or 4 bolts depending on transmission type), turning the crankshaft. To turn off all bolts, turn the hydrotransformer. |
| 11. On cars with system of injection Motronic remove sensors of rotation and an angle of rotation of the crankshaft (see subsection 3.3.6.8). |
| 12. On cars with transmission 4HP22EH disconnect the socket on the left side of transmission. |
| 13. Substitute under transmission the cart with a jack, prop up the pallet through a board and turn off bolts of fastening of support and an intensifying beam to a body. Lower the power unit on a cross-piece of a forward suspension bracket. |
| 14. Turn off bolts of fastening of transmission to the engine. |
|
15. Remove a side lattice in a case of the hydrotransformer (2) and separate transmission, holding the hydrotransformer so that it remained on transmission (1 – a drive plate). In process of removal of transmission the screw-driver make effort in the direction of an arrow. |
| 16. If transmission changes, then rearrange the hydrotransformer on the new unit. For removal screw 2 long bolts in openings of the hydrotransformer and evenly wrapping them. The order of installation is described below. |
|
17. Installation is carried out upside-down. Before assembly blow and wash out pure transmission liquid of a tube of a cooler. On transmission 4HP22EH attach the socket so that tags coincided. Adjust all cables and draft of the selector. |
