BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
   + 3.1.2. Specifications
   + 3.2. Dismantle and capital repairs of the engine
   - 3.3. Engine electric equipment
      3.3.2. Specifications
      3.3.3. The battery - launch of the engine in emergency situations
      3.3.4. Removal and installation of the battery
      3.3.5. Power cables
      - 3.3.6. System of ignition
         3.3.6.2. Check of system of ignition
         3.3.6.3. Check and installation of the moment of ignition (only for the TCI system)
         3.3.6.4. Ignition distributor
         3.3.6.5. Ignition coil
         3.3.6.6. Shaper of impulses and block of electronic ignition
         3.3.6.7. A gap in the shaper sensor (TCI system)
         3.3.6.8. Sensors of system of ignition
      + 3.3.7. System of a charge of the battery
      + 3.3.8. System of launch of the engine
      3.3.9. Malfunctions of the generator
      3.3.10. Main malfunctions of electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


621199f4



3.3.6.8. Sensors of system of ignition

GENERAL INFORMATION

Sensors of an angle of rotation and speed of rotation of the crankshaft of the Motronic system of early release

the socket A – sensors of an angle of rotation

the socket B – sensors of speed of rotation of the crankshaft

 1 – cover of a head of cylinders

Sensors of an angle of rotation and speed of rotation of the crankshaft of the Motronic system of late release

the socket A – sensors of an angle of rotation

the socket B – sensors of speed of rotation of the crankshaft

 1 – starter

Check and replacement

PERFORMANCE ORDER
Sensors of an angle of rotation and speed of rotation of the crankshaft
1. Measure resistance between conclusions 1 (a yellow wire) and 2 (a black wire) from the sensor which has to be 860–1060 Ohms.
2. Measure resistance between conclusions 3 and 2 or 1 who has to be 100 kOhm.
3. If resistance differs, then replace the sensor(s).
4. For replacement unscrew screws and get sensors from nests. Consider that the place of the sensor of an angle of rotation is noted by a letter In, and the place of the sensor of speed of rotation – a letter of D.
Integrated sensor of impulses of rotation of the crankshaft (late models)
5. Disconnect sockets.
6. Measure resistance between conclusions 1 (a yellow wire) and 2 (a black wire) from the sensor on each socket which has to be 500–600 Ohms.

7. If resistance differs, then replace the sensor.
8. For replacement turn off a bolt (the sensor fastens on a cover of a gear belt near a pulley).

9. Get the sensor and replace. The gap (3) between a head of the sensor (1) and a rotor (2) has to be 1,0±0,3 mm. When replacing expose a gap the brass probe.