BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car

BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
- 10. Brake system
   10.2. Specifications
   10.3. Anti-blocking system (ABS)
   10.4. Blocks of disk brakes
   10.5. Support of a disk brake
   10.6. Brake disk
   10.7. Blocks of drum brakes
   10.8. Main cylinder of brakes
   10.9. Vacuum amplifier of brakes
   10:10. Cable(s) of the emergency brake
   10:11. Adjustment of the emergency brake
   10:12. Mechanism of the emergency brake
   10:13. Brake pedal
   10:14. Braking signal switch
   10:15. Hoses and lines of a hydraulic actuator of brakes
   10:16. Removal of air from a hydraulic actuator of brakes
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips

10:13. Brake pedal

GENERAL INFORMATION

Prevention

Height of a pedal of a brake has to be regulated after removal or replacement of the main cylinder of brakes or the vacuum amplifier. At the same time it is necessary to adjust also the switch of a signal of braking.

Adjustment of height of a pedal (the scheme for the car with the left wheel, on the car with the right wheel is carried out similarly)

For adjustment of height of a pedal release a lock-nut (1) and holding a fork, rotate a pusher (2) until the distance And (between bottom edge of an overlay of a pedal and a partition of a motor compartment) does not correspond specified in subsection 10.2.

Prevention

On cars with the right wheel adjustment is carried out on the left side of a shaft after the ware box is removed, however the distance is still measured from a pedal.