BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car


BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engine
+ 4. Cooling system
- 5. Heating and ventilation
   - 5.1.2. Fan of a heater and conditioner
      5.1.3. The control panel of the block a heater - the conditioner
      5.1.4. Heater radiator
   + 5.2. Air conditioning system
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


621199f4


5.1.2. Fan of a heater and conditioner

 Removal, check and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. The fan of a heater is mounted under a dividing partition of a motor compartment and salon and closed by the panel. Unscrew forward and top screws of fastening of the panel of the fan.
3. Get conducting, having disconnected (or having cut off) a binding, and take aside.
4. Remove the panel.
5. Undo locks of a tape of fastening of a casing of the fan.
6. Undo locks of a tape of fastening of the fan.

7. Disconnect wires and remove the fan.
8. Connect the fan to the battery through a fusible crossing point. If operation of the fan is followed by the increased noise, or rotation speed low, then replace the fan electric motor. At removal of a krylchatka designate her situation on an electric motor shaft not to break balancing.
9. Assembly is carried out upside-down.