BMW 3 Series E30

since 1983-1994 release

Repair and operation of the car



BMW E30
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engine
   + 3.1.2. Specifications
   + 3.2. Dismantle and capital repairs of the engine
   - 3.3. Engine electric equipment
      3.3.2. Specifications
      3.3.3. The battery - launch of the engine in emergency situations
      3.3.4. Removal and installation of the battery
      3.3.5. Power cables
      - 3.3.6. System of ignition
         3.3.6.2. Check of system of ignition
         3.3.6.3. Check and installation of the moment of ignition (only for the TCI system)
         3.3.6.4. Ignition distributor
         3.3.6.5. Ignition coil
         3.3.6.6. Shaper of impulses and block of electronic ignition
         3.3.6.7. A gap in the shaper sensor (TCI system)
         3.3.6.8. Sensors of system of ignition
      + 3.3.7. System of a charge of the battery
      + 3.3.8. System of launch of the engine
      3.3.9. Malfunctions of the generator
      3.3.10. Main malfunctions of electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmissions
+ 9. Coupling
+ 10. Brake system
+ 11. Running gear
+ 12. Body
+ 13. Electric equipment
+ 14. Useful tips


621199f4



3.3.6.7. A gap in the shaper sensor (TCI system)

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Measure by the brass probe a gap between a rotor and a plate of the shaper. The probe has to pass under small effort.
3. If the gap differs from standard, then remove the shaper, release fastening screws to a plate and establish a gap.
4. Install the shaper and check a gap.