| 1. Remove a flywheel (drive plate). |
|
2. Turn off bolts of the holder of an epiploon, including 2 lower bolts which to the holder the pallet fastens. |
| 3. Carefully remove the holder with an epiploon, having made an incision consolidation and having tracked safety of laying of the pallet. |
| 4. Carefully clear a demountable surface under the holder of an epiploon. |
|
5. Beat out an epiploon from the inside of the holder, having put it on wooden whetstones. |
|
6. Grease and press a new epiploon blows through a pro-rate. |
| 7. Assembly is carried out upside-down. At assembly clear the holder and the demountable planes of the engine and apply RTV sealant on joints with the block of cylinders and on the acting part of laying of the pallet. |
Tighten bolts of the holder evenly in a cross order, at first tighten fastening bolts to the block of cylinders, then – 2 lower bolts.